3
GENERAL INFORMATION
• Clean a new pool as well as possible before filling pool and operating filter.
Excess dirt and large particles of foreign matter in the system can cause seri-
ous damage to the filter and pump.
• With a permanent media filter in place and operating correctly, clean water
is returned to the pool faster than pool water is being contaminated. A typi-
cal pool installation will require approximately one week to obtain and
maintain the sparkle that your filter is capable of giving you.
• Maximum pressure is 50 PSI (345 kPa). DO NOT connect the filter to a city
water system or to an individual water well system.
Hazardous pressure. Open air release valve to vent all air
from system before operating system. NEVER operate filter with air
trapped inside.
• Th AquaTools
TM
permanent media filter is designed to filter water for swim-
ming pools and spas. On a new installation, we recommend:
1. Disassemble the filter after the initial cleanup.
Hazardous pressure.
To prevent severe injury or major prop-
erty damage, exactly follow "Filter Disassembly/Assembly Procedure" on
Pages 6 and 7.
2. Remove and hose down the element assembly to remove contaminants.
• Maintain pool water pH between 7.2 and 7.6.
• Make sure that internal air bleed tube and filter are clean and installed prop-
erly at top of module before operating filter.
• Make sure that Safe-Lok™ Ring is securely locked in place before operating
filter.
• Maintain pressure gauge in good working order. Replace a damaged gauge
immediately.
• Cleaning interval is based on pressure rise, not on length of time filter is op-
erated. Different water conditions will have different normal cleaning inter-
vals.
• Check local codes for restrictions on waste water disposal requirements.
NOTICE:
Some pool disinfectants may clog filter module. To maximize
module life and filter cycle time, closely follow disinfectant manufacturer’s
instructions when cleaning pool or filter.
Owner’s Information
Serial Number ____________________________________________________
Dealer ___________________________________________________________
Dealer’s Telephone #_______________________________________________
Purchase Date ____________________________________________________
Installation Date ___________________________________________________
Pressure Gauge Reading at Startup ___________________________________
When to Clean the Filter
The filter module should normally be
cleaned when the pressure gauge reading
increases 10 PSI over the start-up pressure
(record the start-up pressure under
“Owner’s Information”, below, right).
In some pools, accessories such as foun-
tains or pool cleaners may be noticeably
affected by the normal decrease in flow as
the filter becomes dirty. If so, clean the fil-
ter more frequently (that is, at a pressure
increase of less than 10 PSI) in order to
maintain the required flow.
H
ea
d
Bo
dy
F
o
re
A
rm
Up
per
Arm
Le
g J
oin
t
Leg Joint
Leg Joint
Head
Body
WARNING
Risk of drowning and
falls. Place equipment
at least 4 feet from pool
so that children cannot
climb over it into pool.
sss
Do not allow children
to stand or play on filter
or pump.
