ACT 2009
- 4 -
INSTALLATION
The controller and sensing unit should be securely mounted on a sound surface.
The controller should be mounted within five feet of a 120 VAC, 60 Hz grounded outlet.
The controller can be wired up to 300 feet from sensor unit (contact ACT for
exceptions). ACT recommends mounting the controller in the most favorable
environment possible.
The
standard well
sensing unit is installed at the water level of the pool. The
center of the clear ½” PVC tube on the sensing unit should be at the normal
operating water level of the pool. An isolated static water line from the pool to
the sensing unit is necessary to provide stable water conditions. A valve
arrangement is provided. The valves are installed so that the operator may
maintain and clean the sensing unit.
The
sight glass
sensing unit is installed by attaching the unit to a balance tank
sight glass. The sensor should be mounted at normal operating water level of the
balance tank using the included clic connectors.
The
wet well
sensing unit is installed in a 2” PVC pipe which serves as a still
water stand pipe from the pool. The normal water level should sit approximately
1 ½” from the bottom of the end cap.
The
surge tank
sensing unit is installed in the surge tank at normal operating
water level with the included clic connectors. The normal water level should sit
approximately 1 ½” from the bottom of the end cap.
The
deck well
sensing unit is installed at pool side. The unit has a ½” static line
sight glass inside to attach a sight glass sensing unit to (sensing unit and sight
glass provided). The deck well is connected to the pool using a 2” static line.
Conduit connection and drain connections are also present to make installation
quick and easy.
The three conductor extension cable provided with the system is the electrical
connection for the sensor unit to the controller. With the standard well, sight glass, wet
well and deck well, a terminal strip is provided in the sensor housing for terminating the
cable (a wiring diagram is located inside sensor box for standard well, sight glass, wet
well, and deck well applications). The other end of the cable terminates inside the ELC-
800r. The interconnecting cable carries low voltage. Local codes may require the cable
to be housed in conduit.
Refer to
www.aquaticontrol.com
for sensing applications, drawings, and other product
information offered by AquatiControl Technology.
