Drip Loop
SET-UP YOUR FIXTURE
➊
Read the Safety Instructions.
Plug in the power cord to the light fixture.
➋
Turn on your phone’s Bluetooth®.
➌
Download the HME AQUA
App from the App Store or
Google Play.
➍
Open the HME AQUA
App. The fixture will
be listed in the
Device List.
Tap on the fixture
to connect.
If you do not see any
fixtures,
Tap Search
to refresh the list.
Enter the passcode
for the fixture:
24897673
➎
Tap Schedule on
the bottom menu
and then select the
part of the world
where you would
like to mimic the
natural sunlight.
SET-UP (cont.)
➏
The Sunrise & Sunset
will automatically
be set based on the
part of the world
you select.
You can modify the
times by
tapping on
the pre-set time.
➐
When finished,
Tap
Submit to transfer
settings to the fixture.
Close the App and the
fixture will continue to
run on the program.
That's it. You are all set to
enjoy your new light!
A)
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
B)
DANGER – To avoid possible electric shock, special
care should be taken since water is employed in the
use of aquarium equipment. For each of the following
situations, do not attempt repairs by yourself; return
the appliance to an authorized service facility for
service or discard the appliance:
1) If the appliance falls into the water,
DON’T reach for it! First unplug it and then
retrieve it. If electrical components of the appliance
get wet, unplug the appliance immediately.
(non-immersible equipment only)
2) If the appliance shows any sign of abnormal water
leakage, immediately unplug it from the power
source. (immersible equipment only)
3) Carefully examine the appliance after installation.
It should not be plugged in if there is water on parts
not intended to be wet.
4) Do not operate any appliance if it has a damaged
cord or plug, or if it is malfunctioning or has been
dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug or
receptacle getting wet, position aquarium stand
and tank to one side of a wall-mounted receptacle
to prevent water from dripping onto the receptacle
or plug. A “drip loop,” shown in
the figure to the left, should be
arranged by the user for each
cord connecting an aquarium
appliance to a receptacle. The
“drip loop” is that part of the
cord below the level of the
receptacle, or the connector
if an extension cord is used, to
prevent water traveling along
the cord and coming in contact
with the receptacle. If the plug
or receptacle does get wet,
DON’T unplug the
cord. Disconnect the fuse or circuit breaker that
supplies power to the appliance. Then, unplug and
examine for water in the receptacle.
C) Close supervision is necessary when any appliance
is used by or near children.
D) To avoid injury, do not contact moving parts or hot
parts such as heaters, reflectors, lamp bulbs, and
the like.
Scan to Download
the HME AQUA App
E) Always unplug an appliance from an outlet when
not in use, before putting on or taking off parts,
and before cleaning. Never yank the cord to pull
the plug from outlet. Grasp the plug and pull to
disconnect.
F) Do not use an appliance for other than intended
use. The use of attachments not recommended
or sold by the appliance manufacturer may cause
an unsafe condition.
G) Do not install or store the appliance where it will
be exposed to the weather or to temperatures
below freezing.
H) Make sure an appliance mounted on a tank is
securely installed before operating it.
I) Read and observe all the important notices
on the appliance.
J) If an extension cord is necessary, a cord with a
proper rating should be used. A cord rated for
less amperes or watts than the appliance rating
may overheat. Care should be taken to arrange the
cord so that it will not be tripped over or pulled.
K) For added safety, the appliance must be plugged
into a receptacle controlled by a GFCI (ground
fault interrupter) circuit breaker. The device must
be properly connected to a grounded three-prong
receptacle.
L) This appliance is intended
FOR HOUSEHOLD
USE ONLY.
M)
SAVE THESE INSTRUCTIONS.
2
3
HM Electronics Edge Series
Models: 420343, 420344, 420345
Installation, Operation & Maintenance Guide
www.aquaticlife.com
WARNING:
Please read carefully before proceeding with installation. Your failure to
follow any attached instructions and operating parameters may lead to the product’s failure.
