Aquaticausa.com
Aquaticabath.ca
E: [email protected]
True Ofuro Tranquility
Warning
WARNING
1. READ AND FOLLOW ALL INSTRUCTIONS
2. WARNING: When using electrical products, basic precautions should always be followed, including the following:
3. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all
times.
4. Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the
manufacturer.
5. Never drop or insert any object into any opening.
6. Do not operate this unit without the guard over the suction fitting.
7. DANGER: RISK OF ELECTRIC SHOCK. The unit must be connected only to a supply circuit that is protected bya
ground-fault circuit-interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB). Such a GFCI should be provided by
the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt
power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is
defective. If the GFCI interrupts power to the bathtub without the test button being pushed, a ground current is flowing,
indicating the possibility of an electric shock. Do not use this hydromassage bathtub. Disconnect the hydromassage
bathtub and have the problem corrected by a qualified service representative before using.
8. WARNING: RISK OF ELECTRIC SHOCK. A licensed electrician should make all electrical connections. Disconnect
power before servicing.
9. WARNING: RISK OF INJURY OR PROPERTY DAMAGE. Please read all instructions thoroughly before beginning
installation, including the following requirements.
10. Follow all local plumbing and electrical codes.
11. INSTALL TO PERMIT ACCESS FOR SERVICING.
12. (For permanently connected units) A green-colored terminal (or a wire connector marked G, GR, Ground, or
Grounding) is provided within the terminal compartment. To reduce the risk of electric shock, connect this terminal or
connector to the grounding terminal of your electric service or supply panel with a conductor equivalent in size to the
circuit conductors supplying this equipment. A pressure wire connector is provided on the exterior of the pump or
control within this unit to permit connection of a bonding conductor between this unit and all other exposed metal in the
vicinity, as needed to comply with local requirements.
GROUNDING IS REQUIRED.
The unit must be installed by a qualified service representative, and grounded. Building
materials and wiring should be routed away from the pump body and other heat-producing components of the unit.
