Aquatic
15
Builders' Choice Owner's Manual & Installation Guide
4.
How do jets function?
Directional
Jets:
Figure 3
• Water flow can be adjusted by turning the face plate of the jet.
• Adjust the pressure by rotating the face plate of individual jets,
counterclockwise for more pressure, clockwise for
less pressure.
Rotary
Jets:
Figure 4
• Spinning jets add enhanced massage action to the
bathing experience.
• Located in key positions to target back muscles and feet.
5. Optional in-line heater -
The optional inline heater is factory installed
and pre-set to maintain water temperature at 104°F (40°C). If
the water is too hot, adjust the temperature by adding cold
water. Make small adjustments and always test the water prior
to entering the tub. The inline heater has a water flow sensor
which prevents it from being operated
when the pump/motor is off.
If all systems are “GO” -
You’re ready for your whirlpool bath.
If system doesn’t operate as described -
Turn it off immediately. Go over and repeat each of the preceding steps. If it
still won’t work refer to the
TROUBLESHOOTING GUIDE
on page 20.
6. Enter the bathtub. Sit back, stretch out, relax. Push the on/off button (if so equipped).You’ll feel water being pumped
gently out of the jets. Turn the jet nozzles to direct the air/water mixture against aching or tired limbs and muscles or
adjust the nozzles to create maximum whirlpool action in the bathtub. Adjust the pressure by rotating the face plate of
individual jets, counterclockwise for more pressure, clockwise for less pressure.
OPERATION INSTRUCTIONS
Figure 3
Figure 4
FCC CONSUMER INFORMATION
Electrical Installation Information Listed on pages 11-12.
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance
with the manufacturers instruction, may cause interference to radio and television reception. It has been type tested and found to
comply with the limits for a class B computing device in accordance with the specifications in subpart J of part 15 of the FCC
rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference, which can
be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient the receiving antenna.
• Relocate the receiver with respect to the bath tub.
• Move the receiver away from the bath.
• Plug the receiver into a different outlet so that the receiver and bath are on different branch circuits.
• If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
• The user may find the following booklet prepared by the FCC helpful: “How To Identify and Resolve Radio-TV Interference
Problems.” It is available from the U.S. Government Printing Office, Washington, DC 20402, Stock No., 004-000-00345-4.
