Technical Products
Technical Products
Cautions
The Aquachill 200 must be placed in an area with good ventilation.
Avoid exposing it to direct sunlight.
(fig. 16)
DO NOT to put it in a
small, confined place, in order to prevent a decrease in efficiency.
The Aquachill 200 is operated by a power source.
Careful !!! Always
put the position on 230V when the power source of your home is
220/230V (fig. 28). In case of a wrong setting (for example; using
115V position on 220/230V , the power source will be severely
damaged (short circuit)
. No warranty applies in this case.
Put the Aquachill 200 on a flat and stable surface.
(fig. 18)
Please read carefully before
installing the AquaChill 200
The Aquachill 200 produces heat while cooling, so make sure the air
inlet and outlet of the Aquachill 200 is not blocked. Assure a good air
flow, as it increases the efficiency of the Aquachill 200.
(fig. 17)
The recommended content of the tank is approx. 200 liters.
Indoor use only.
(fig. 19)
Avoid the power source and the AquaChill 200 body getting wet
(fig. 20).
Make sure the connections of the power cord and d.c. 24V are set
correctly. This avoids electrical damage
(fig. 21).
Installation
- Turn the screw(s) of the water inlet and outlet to the lowest position.
(see direction fig. 22)
- Put the tubes over the water inlet and outlet
(fig. 23)
- Push the tube until it reaches the lowest part of the outlet / inlet
connection.
(fig. 24)
- Tighten the screw(s) by hand
(see direction on fig. 25)
- Plug the connecting wire of the AquaChill 200 into the Power source
(6-Pin connection)
(fig. 26a & 26b)
- Put the plug in the socket of power source before determining
the voltage. Do not connect the power cord.
(fig. 27)
- After completion of the basic installation, let the water circulate
5 ~ 10 minutes. Make sure there are no air bubbles left in the water
pipe.
The AquaChill 200 is now ready for use.
You can now
connect the power.
(fig. 29a)
Make sure the power cable is in a
loop.
(fig. 29b)
Careful !!! Always put the position
on 230V when the power source
of your home is 220/230V . In case
of a wrong setting (for example;
using 115V position on 220/230V ,
the power source will be severely
damaged (short circuit)
.
www.aquatic-nature.com
www.aquatic-nature.com
