aquatherm AT700, Руководство по эксплуатации для владельца

Страница: 2 / 6

A. Introduction .......................................................................................................................... 2
1. Unit Description ..................................................................................................... 3
2. How A Heat Pump W orks ...................................................................................... 3
3. LED Display & Status Light Descriptions ........................................................ 4-5
B. Operational Instructions..................................................................................... Pages 6 - 7
1. W ater Flow
2. W ater Pump Timer Setting
3. Thermostat Setting & Mode Selection
4. Optional Time Clock Override Switch
5. T ime Delay Modes
6. Normal Operation Indicators
7. Pool/Spa Cover Use
8. Spa Heating
9. Defrost Control In Cold W eather
C. Heat Pump Maintenance & Precautions ........................................................Pages 8 - 12
1. Air Flow & Service Access Clearances
2. Freeze Condition Precautions
3. Owner Cleaning & Maintenance
4. Professional Maintenance
D. Operational Sequence & Troubleshooting Flow Chart .................................................. 10
E. Warranty Service .............................................................................................................. 11
Table of Contents
A. Introduction
Congratulations on the purchase of your new swimming pool/spa heat pump. Utilizing heat
pump technology is the most efficent method of heating a swimming pool. Please take a few
minutes to read this owner ’s manual to familiarize yourself with the operation and features of
the heat pump.
Please be sure to fill out the warranty card and send it back to us. If you have any questions
regarding your heat pump, or if you have a need for service, please contact us at our toll-free
number listed on the back page.
Important Information to Record
Installer Name ________________________________________________________________
Installer Phone ____________________________ Install Date __________________________
Model Number _________________ Serial Number __________________________________
Page 11
E. Warranty Service
Before calling for warranty service you should check the following:
1. Clean all filters and traps in the pool circulation system. Low water flow will cause the unit
to shut down or cycle.
2. C hec k a nd adj ust al l w ate r fl ow va lve s a nd adj ust to th e p rop er p osi tio ns to ins ure pr ope r w ate r
flow through the heater.
3. Check the water pump timer setting to insure there is enough time all otted for a proper heating
cycle.
4. Check all circuit breakers and disconnects. Note: More than one disconnect may be required
to shut of f or turn on power to the heater .
5. C onfi rm th at all hea ter c ont rol s, the rm ost at, the rm ost at sel ect or sw itc h, res et tri ppe r, and
optional auto heat switch (if so equipped), are in the correct position.
6. If a ny 3rd pa rty co ntr ol d evi ces ar e in sta lle d o n th e p ool /sp a sy ste m m ake su re the y a re fun ctio n-
ing properly . Factory service technicians will not diagnose 3rd party external control devices.
All external controls are disconnected during warranty service and the heater is diagnosed as
manufactured then reconnected.
7. The limited factory warranty does not cover damage or conditions caused by but not limited
to the following:
Improper installation.
Improper use.
Inadequate run time on the water pump timer.
Improper water flow to the heater.
Conditions caused or associated with 3rd party external controls.
Sprinkler damage.
Roof run of f damage.
Freeze damage or operation damage during freezing conditions.
Salt and/or sand or debris damage.
Lack of maintenance and/or cleaning.
Unauthorized servicing of the heater during the warranty period.
Normal rusting and oxidation of metal components.
Non warranty service calls such as inspections, maintenance, or problem s unrelated to the
heater as it was manufactured are not covered under the warranty .
8. Y ou can contact the factory @ 888-297-3826 to be pre-qualified and scheduled with a factory
authorized service center in your area. Have your model number , serial number and installa -
tion date ready .
IMPO rTA nT nOTES :
The heater will not heat faster if you turn the thermostat all the way up. The heater will never run
without water running through it from the pool/spa filter pump. When the heater is started the
fan will run right away . The compressor will start after a 5 to 7 minute delay . The heating light
will come on only when the compressor is running. The heater will produce condensation at a
steady rate. The condensation exits the heater from the bottom drains. The more humidity the
more condensation. The thermostat is accurate within three degrees and may not always match
exactly to the degree numbers printed on the control panel as it is ef fected by the humidity and
other factors. The heater is designed to shut of f in defrost mode when the air temperature drop
below 45˚F to 50˚F.
NOTICE
Technicians See Separate “Installation Manual”.
Specifications may change without notice.