aquatechnik BBS 32, Инструкция по эксплуатации

Страница: 19 / 76

COUPLING TOOL STOP DURING PROCESSING
(BLOCKED PIPE)
If the Coupling tool BBS 32 stops during the working cycle, follow these simple steps:
1)
unscrew the mechanical expander (G) (even by a
few revolutions only) in order to release the pipe
as illustrated in the picture beside;
2) bring the machine back into return position as
indicated in chapter "Manual return of coupling tool
BBS 32;
3) check that the conical pin is lubricated. On the
contrary, lubricate the conical pin with the suitable
grease (Item# 50825).
If the problem is not solved, send the Coupling tool BBS 32 to
aquatechnik
for eventual verification and
repairing.
COUPLING TOOL STOP DURING PROCESSING
In the event of machine block (the conical pin cannot
go forward or backward), see the following
instructions:
1)
remove the tank cap (I) as illustrated in picture
11;
2) loosen the vent hole cap (L) by an Allen wrench
(3 mm) as illustrated in fig. 12;
3) press against the rubber tank in order to let air
go out of the vent hole. When air is completely
discharged and oil starts coming out (fig. 13),
close the vent hole cap (L) by the Allen wrench;
4) replace the tank cap (I). Repeat these steps, if
needed.
If the problem is not solved, send the Coupling tool
BBS 32 to
aquatechnik
for eventual verification and repairing.
19
BBS 32
(patented)
ENGLISH
Picture 13
Picture 12
Picture 11
Picture 10
Picture 9
istruz_bicchieratri_BSB32-multilingue_Layout 1 15/02/11 08.32 Pagina 19