4 — INSTALL RO FAUCET
You will need a sink top hole between 11/2" and 15/8" in diameter. If drilling a new hole, ensure
faucet body will mount flat against surface and that there is sufficient tubing between faucet
body and system manifold. NOTE: Drilling holes into solid surfaces or surfaces made of stone
should only be performed by a qualified and certified installer.
1
Attach remaining 3/8" white tubing to stem on faucet body by wetting tubing end and
inserting into faucet stem fitting approximately 5/8" until it stops. Gently tug on the tubing
to ensure it is firmly seated in fitting.
NOTE: Do not connect 3/8" white tubing from tank to faucet.
2
Mount faucet base by pushing toggle bolts through the sink hole until faucet base is flush
with countertop. Position toggle bolts under sink surface being certain faucet stem will
not be obstructed. Loosely fasten faucet base to countertop by tightening toggle bolts,
alternating between left and right sides to evenly tighten. Leave loose to adjust faucet
body as desired.
3
Route the 3 tubes attached to faucet body through the faucet base and through hole in sink
until approximately 12" of tubing remains above sink.
4
Turn 1/4 clockwise and holding faucet base firmly, mount faucet body to faucet base. Adjust
faucet body handle to desired location.
5
To tighten faucet, hold base firmly to keep it from moving while turning faucet body 1/4 turn
counterclockwise. Tighten toggle bolts evenly, making sure not to over tighten.
6
Mount faucet body to faucet base; turn 1/4 turn clockwise until it locks.
7
Attach faucet spout to faucet body by screwing spout nut to body.
5 — INSTALL RO DRAIN CONNECTOR
WARNING
CAUTION
Be sure that all electrical appliances and
outlets are turned off at the circuit breaker
before working in the cabinet area.
Please wear safety
glasses to protect
eyes when drilling.
1
Identify drain outlet location.
2
Remove protective cover from back of foam seal.
3
Knock center hole out, align holes, and attach to front plate of drain connector.
4
Allowing room for drilling, position the drain connector on sink drain pipe above drain trap.
5
Securely tighten nuts and screws.
6
Using drain connector port as drill guide, drill 7/32" hole through wall of drain pipe. Be sure
not to penetrate opposite side of pipe, and be careful not to damage side of drain port
fitting.
COLD
HOT
1
2
5
3
6
4
7
