1. Turn off water supply to refrigerator
2. Locate an easily accessible section of refrigerator water supply tubing or supply line to
refrigerator from under-sink.
3. If installing on the back of a refrigerator; cut and remove a
11.5” section of refrigerator water supply tubing.
• Use a tube cutter for copper tubing and a utility knife for plastic
tubing. Make sure ends are square.
4. Referring to “Using Push-In Fittings” section below, insert refrigerator water supply tubing into
inlet push-in fitting on filter.
5. Turn on the incoming water supply and flush the filter into a
bucket. Run water for 2-3 minutes. The initial surge of water may be
discolored due to carbon fines.
6. Shut off water supply again. Referring to “Using Push-In Fittings”
section, insert water supply tube from refrigerator into outlet fitting.
7. Use plastic strap to secure filter to back of refrigerator or under sink.
8. Turn on water supply to refrigerator and check for leaks.
Filter Replacement
1. Turn off water supply to refrigerator.
2. Referring to section “Using Push-In Fitting”, release tubing from both ends of filter.
3. Referring to “Using Push-In Fittings” section, insert refrigerator water supply tubing into inlet
push-in fitting on filter.
4. Turn on the incoming water supply and flush the filter into a bucket. Run water for 2-3 minutes
to flush out air.
5. Shut off water supply again. Referring to “Using Push-In Fittings” section, insert water supply
tube from refrigerator into outlet fitting.
6. Turn on water supply to refrigerator and check for leaks.
Troubleshooting
If water leaks at Push-in Connections: Push tubing in as far as it will go. If leaking continues, shut
off water at the original valve and remove water line by pushing in on the connector collar while
pulling the tubing away. See,
“Using Push-In Fittings”
section. Inspect tubing for cracks and
scratches. If tubing is cracked or scratched, simply cut that portion away and reinsert new end of
tubing into fitting. Make sure tubing is cut straight. If not, re-cut.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Collet
baCkstoP
Using Push-In Fittings
To Release Tubing
Push in grey collet to release tubing.
With collet held, pull tubing straight out.
To Attach Tubing
Push tubing in as far as it will go. tubing must
be inserted past o-ring and hit backstop. Pull
tube to ensure it is secured.
Filter Installation
Parts and Material Included
• Filter Cartridge
• Adjustable plastic strap
• Installation instructions
tools & Parts Needed
• Tube Cutter or Utility Knife
• Bucket for flushing filter
Install in a location that is
not susceptible to freezing
temperatures.
Install away from direct sunlight
as prolonged exposure to light
can weaken plastic components.
a water supply line must be run
to the refrigerator or fountain
prior to installation of this filter.
Correct
Incorrect
FLOW
