INSTALLATION INSTRUCTION
1.
Commercial Ozone Water Purifier will offer two metallic plates, a power adapter, 4-1/4 tapping
screws, a hose, and a screwdriver as accessories.
2.
Commercial Ozone Water Purifier should be fastened to the wall, left above your tap. Firstly,
fix the metallic plate on the wall. The metallic plate has three mounting holes, together with 3
anchor screws. Fasten the metallic plate on the wall with the anchor screws to support the
product.
3.
Before installation, do not open the unit. There are 6 sockets on the bottom of the unit.
Collimate
the 6 sockets in the holes of the metallic plate, pull downward slowly, and then the
unit is hanging over the metallic plate.
4.
Ensure that metallic plate is horizontal. Tilt installation may affect the product operation and
visualization.
5.
Connect the water inlet on Commercial Ozone Water Purifier to the cold water supply faucet;
and connect the water to your washing machine with the supplied hose. Make sure rubber
washers are properly installed in both ends of the hose before connection. Properly tighten the
hose to the inlet fitting, but do not over tighten.
6.
Plug the supplied power adapter into the DC adapter plug-in on the side of Commercial Ozone
Water Purifier unit and then plug the adapter into the wall outlet. Disconnect the power adapter
when not use the unit.
