HOTLINE
1300 278 283
PHONE
+61 (8) 6260 1000
WEB
WWW.AQUAPROONLINE.COM.AU
AP300SP / AP960SP / AP1360SP SOLAR
PUMP
INSTRUCTIONS
ASSEMBLING THE FOUNTAIN KIT
ASSEMBLING THE SOLAR PANEL
• To create a small fountain, fit your selected
nozzle and extension tubes to the top of
the pump outlet by pushing or screwing
(depending on the model). There are different
nozzles for different effects. To produce the
effect, it is best practice for the fountain head
or nozzle to be positioned 5 - 10cm above the
water surface. It is best to keep the pump off
the waterfeature base to avoid drawing the
waste and debris into the pump, otherwise
it may lead to a blockage in the pump. A
household brick is sometimes used for this
purpose.
• If you choose to connect tubing to the pump
instead of the fountain kit, we recommend
using one of the riser stems from the fountain
kit to push inside 13mm hose. You may need
to utilize hot water to soften the tube and
expand the diameter to fit over the riser end.
Remember to use Stainless Steel hose clamps
to fasten the hose on to the Hosetail. This is
to ensure that the pipe does not blow off at a
later time or leak at this point in the plumbing
system. Direct the hose in your desired
direction.
• Place the pump in the desired location. Ensure
the pump is on a stable, raised surface free of
sludge, sand, and other debris. Do not place
the pump directly on the water feature floor or
in mud.
• Connect the pump to the solar panel and
tighten the protection nut.
• Install the solar panel on the lawn or garden by jabbing the spike (2) into the ground. Adjust the
orientation of the panel (1) to face towards the sun and then tighten the screw on the back of the
panel to secure.
• Make sure to keep the pump (3) fully submerged in water while the pump is in operation.
• The solar pump should now operate.
1
2
3
AQUAPRO Solar AP300_960_1360 Instructions.indd 5
AQUAPRO Solar AP300_960_1360 Instructions.indd 5
13/5/2022 8:26 am
13/5/2022 8:26 am
