FOLLOWING THE WATER FOUNTAIN INSTALLATION AND CONNECTION
5
In the case of the Crystal EKО-80-2 water fountain:
- open the cold water supply, check the tightness of the device;
- open the clean water tap
(5)
;
- using the water connection
(2)
(set the handle to the "open tap" position), adjust the
water flow in accordance with the recommended filtration rate of the device;
- let the water run for 10 minutes;
- turn off to clean water tap
(5)
and wait 10 minutes;
- then run the water again for 50 minutes;
- turn off the tap to clean water
(5)
;
- check the tightness of the connections;
- the fountain is ready for use;
In the case of the Crystal H-80-2 water fountain:
- instead of the KH insert, install a plug (included in the set or may be purchased
separately);
- open the cold water supply, check the tightness of the device;
- open the clean water tap
(5)
;
- using the water connection
(2)
(set the handle to the "open tap" position), adjust the
water flow in accordance with the recommended filtration rate of the device;
- let the water run for 10 minutes;
- turn off the tap to clean water
(5)
, wait 10 minutes;
- then run the water again for 40 minutes;
Please Note: When draining the water with the cap fitted, check for accidental
leaks.
- put the KH cartridge in the right place and let the water run for another 10 minutes;
- turn the clean water off
(5)
;
- check the tightness of the connections;
- the water fountain is ready for use;
