8
Fig. 3: Bushing or tank fitting
(the glass pane is placed between slide ring 3 and rubber ring 2)
1.
Thread
2.
Rubber sealing
3.
Slide ring
4.
Nut
There is a blue fitting in the mounted bend of the return line. Here, air is sucked in when the pump in the cabinet
fails. This prevents the formation of communicating pipes and an overflow of the filter tank by returning water.
When starting the aquarium, water has to be filled in until the filter tank is filled up to 10 – 12 cm in the front
part and then the pump has to be started. If the water level in the filter tank decreases, water has to be filled
in until the a.-m. maximum is reached. Take care that enough space is left so that the inflowing water in case
of failure or shutdown of the circulation pump still fits into the filter tank. The cables of circulation pumps or
other parts mounted in the aquarium can be routed through the empty conduit downwards. If a plug is too big
for this, the profile slid onto the rear panel can be cut with a PUK saw so that cables can be led out of the
aquarium at the back. The back side should, however, remain closed to allow the fan to suck in air in the
aquarium and not from the outside.
3.
Skimmer EVO 500
See separate manual. The skimmer is hooked to the rear wall of the filter sump with the holding unit without
screws (refer to Fig. 2).
4.
Lighting aquarius 60 (please refer to the attached manual)
Fig. 4: Holder for aquarius
•
Take care that no humidity and no salt enters the interior of the lighting system!
