LUMA-Vu Gen2 Fitting Instructions
All Aqualuma lights have been tested before shipping.
It is recommended that you use a qualifi ed boat builder to work out placement and fi tting of your new LUMA-
Vu Underwater Camera
You will require the following to install your new Aqualuma LUMAVu Camera.
*60mm (2 & 3/8 in”) hole saw, Wire Connectors *Fuse or Circuit Breaker
Gen 2 series housings can now be installed with any sealant approved for below water
line use.
Step 1
With boat on hardstand or trailer calculate the position for the camera housing. (Recommended
depth is 300mm (10 in”) below water line. Mark the hole centre with a marker, be careful to check
the inside of the boat for any obstacles in the area you want to drill, with that done you can now
drill a small pilot hole then double check inside the boat again for anything that may obstruct the
housing or retaining nut. Once you are sure you have the correct position you can now drill trhough
the hull with the 60mm (2 & 3/8 in”) hole saw.
Step 2
Remove the Camera from box, do not disassemble the unit, remove the retaining nut from the
housing and clean the inside surface of the fl ange with a dry cloth. Clean the surface of the hull
removing all antifouling from fl ange area and wipe clean.
Step 3
You are now ready to install the complete Camera fi tting into the hull (there is no need to
disassemble Camera fi tting). Apply a generous amount of sealer to the inside fl ange of the
housing and carefully slide the housing into the hole with someone inside the boat to attach the
nut.
Align the arrow to the up position this is critical to make the camera orientation correct on the
video screen,
hold the housing fl ush with the outside surface of the boat and apply a small amount
of sealer to inner surface around hole and tighten the nut by hand until tight. The nut should only
be hand tight.
Step 4
Clean excess sealant from around the housing and check to make sure you have a seal all the way
around the fl ange to the outside edge of the housing. Check the face of the housing and lens area
for any sealant.
Step 5
Take the power wire and run to a known 12 volt DC fused and switchable power source with 5
amp fuse as each Camera uses only 130ma @ 12 volts DC do not use higher fuse, connect the red
wire to positive and the black wire to negative. You can then run the RCA video lead to any video
input in the boat.
Please note Aqualuma Camera are polarity sensitive.
Congratulations on purchasing and installing your new Aqualuma Underwater Camera you are
now ready to view the water and sea life around your boat and be the envy of your friends who
have not yet seen or experience the wonders of the sea life below their boat.
