Hydrocell Pre-2006
2 DIL & 4 DIL Common
Set Up
1. Connect your CR-P2 battery to either Battery Connector terminal.
2. To enter test mode; Flick DIL switch No1 into the ON position (UP)
and back OFF (DOWN).
3. The solenoid valve will briefly click open and close. After 20 seconds
the unit will enter test mode and the Hydrocell will detect
movement. Upon detection, the valve will briefly click open and
close, this will continue on detection.
4. If the cistern is empty jump to
Stage 5
. If the cistern is
not
empty
follow this procedure:
Press and release the fill button, this will
open the valve and allow water into the cistern. When the
cistern begins flushing, press the fill button to close the
valve. The cistern will now be empty. Flick DIL switch No1
into the ON position (UP) and back OFF (DOWN) and wait for
5 seconds.
5. Press and release the fill button, this will open the valve and allow
water to flow into the cistern. When the cistern begins flushing,
press and release the fill button to close the valve.
C o n t i n u e d .
Battery
connector
DIL Switch
Fill Button
Battery
connector
