Aquallice KRIBA, Быстрый старт

Страница: 10 / 16

POOL
FILTER
KRIBA
1. PACKAGING COMPONENTS
The filter you just purchased has been
specially designed for pools. Thanks to
its design and functionality you have all
necessary elements to clean and filtrate
the water of your pool. This packaging
contains the filter body and the valve. Main
components of this filter are the following:
2. BEFORE CONNECTING
THE FILTER
Location
The filter must be installed as close to the
pool as possible, preferably within 50 meters
of the surface of the pool. Be sure there is a
drainpipe in the spot where the filter will be
located. This drainpipe must be adequately
sized to the installation flow.
Be sure the surface area where the filter is
installed is horizontal, stable, resistant to the
weight of the filter, and is completely clean.
There must be enough space in the area
around the filter so that the required
inspections and maintenance throughout the
life of the pool can be carried out.
Installation
Once the filter has been placed in the right
location proceed as follows:
• Make the three connections needed for the
selector valve:
1. pump tubing to the valve,
2. valve to the waste drain
3. and from the valve to pool return
Each of the three outputs is identified on the
valve. See figure no. 3.
• Install the selector valve in the filter,
ensuring that the gaskets between the
valve and the filter are correctly positioned
and none of the gasket has dropped inside
the filter tank. Place the bag to avoid sand
getting into the pipe.
• Fill the filter with water up to the half way
point. Pour the necessary quantity of sand
into the filter. It must be filled with silica
sand with a particle size from 0.4 to 0.8
mm. with the quantity indicated in the table
of characteristics. Silica sand should be
only replaced in case of sand loses. See
figure no. 4
• Clean the area around the cover seal and
remove the bag..
• The nuts of the cover must be strongly
tightened.
SAFETY NOTICE, PLEASE READ THEM CAREFULLY
• All electrical connections should follow the European Standard regulation
NF C15-100
NF EN 60-335-2-41
• Which refers to «construction of electrical installations«, both in outdoor as in indoor pools,
or similar regulations specific of each area or country.
• Electric installation should be performed by a professional qualified for electric installations.
• When filling the tank with sand, sand should not exceed 2/3 of the tank height.
• Do not start the device before it has been previously primed.
• When handling the filter or valve, always disconnect it from the electricity supply.
• Do not allow children or unauthorized adults to manipulate the filter.
FIG. POS. DENOMINATION
1 1 Cover
1 2 Filter body
1 3 Out filter
1 4 Filter base
2 1 Manometer
2 2 Air relief valve