Visage Digital exposed
installation instuctions
page 7
Flush through both the 15mm copper hot and cold supply pipes.
5
The maximum hot water inlet temperature should be no more than 65˚C.
!
Place the Digital processor on a solid
mounting surface, mark and prepare the
fixings before securing the processor to the
mounting surface using the screws provided.
4
Choose the position for your Digital processor
as close to the shower control as possible.
The processor may be sited in the roof space
above the proposed shower site, in the airing
cupboard or behind a screwed bath panel if
more convenient. If siting in the roof space,
ensure that freezing cannot occur and that no
insulation material is placed under or over the
processor. Please refer to the system layout diagrams overleaf.
3
!
THE PROCESSOR MUST BE SITED IN A POSITION THAT IS SAFELY
ACCESSIBLE FOR SERVICING AND COMMISSIONING PURPOSES. WHEN
FITTED IN THE LOFT SPACE, THE ROUTE TO AND THE AREA AROUND
THE PROCESSOR MUST BE BOARDED TO ENSURE A SAFE WORKING
ENVIRONMENT.
The optimum position for the Digital processor is in the roof space above
the shower site to take full advantage of the ease and speed of installation -
please refer to the note above.
The distance between the Digital processor and shower control must be
within range of the 10m data cable supplied.
6
Connect the supply pipes to the Digital
processor, ensuring that the cold and hot
feeds are fitted into the appropriately
marked inlets.
DO NOT SOLDER NEAR TO PLASTIC
COMPONENTS.
!
If fitted, remove the controller front cover from the rail assembly. Unscrew
the two front cover captive screws at the bottom of the back plate. Carefully
lift the controller from the bottom of the back plate, disconnect the data
cable and pull the cover clear.
7
