22
2
Feed the wall outlet thread through a 22-28mm hole in the wall
and secure with the backnut ensuring the backnut washer is fitted
between the backnut and the wall, if accessible.
3
Connect the wall outlet to a suitable ½” female connector using PTFE
tape or similar, to achieve a watertight seal.
4
Temporarily cap off the wall outlet, open the shower valve and check
for leaks.
Without rear access:
1
Run pipework from the shower valve to the desired location for the
wall outlet ensuring it terminates in a suitable ½” female connector
(not supplied). All pipework and connectors must be secured using
suitable fixings.
2
The backnut and backnut washer are not required. Wind the wall
outlet thread directly into the ½” female connector (not supplied)
using PTFE tape or similar, to achieve a watertight seal.
3
Temporarily cap off the wall outlet, open the shower valve and check
for leaks.
