Adjusting Water Flow and Spray Angle
1. During operation, use the water flow throttle
to adjust the water flow (Fig. 4).
NOTE:
The water flow rate can be adjusted
from as low as 2.8 GPM to as high as 3.3
GPM. Generally, with a higher water flow rate
there will be more water released from the
trigger gun. If the foam cannon is used, the
detergent in the bottle will be used up sooner
with a higher water flow setting.
2. When using the Quick-Connect spray nozzle,
the spray can be adjusted from 0° pencil
spray to 65° fan spray as needed by turning
the nozzle tip (Fig. 5).
Working with Foam Cannon
For additional cleaning power, the unit comes
equipped with a foam cannon spray bottle.
1. Remove the foam cannon cap with detergent
suction tube from the detergent bottle. Fill
the detergent bottle with proper detergent
mixed with water as instructed on the
detergent label/manual (Fig. 6).
Fig. 4
Water flow Throttle
Increase
Decrease
Fig. 5
0° Pencil Spray
65° Fan Spray
2. With the trigger released and the water
supply shut off, disconnect the Quick-
Connect spray nozzle by pulling back the
Quick-Connect collar (Fig. 7).
NOTE:
Do not make change to nozzles when
the sprayer is on.
3. Snap the foam cannon onto the Quick-
Connect collar until it clicks into place
(Fig. 8).
4. Turn on the water supply, and squeeze the
trigger. The detergent in the bottle will be
sprayed on the car.
Fig. 6
Foam cannon
cap with
suction tube
Detergent bottle
Fig. 7
Quick-Connect
Spray nozzle
Quick-Connect
collar
Fig. 8
Trigger gun
Foam cannon
4
