Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966
for more info go to:
www.Aquaglide.net
8
6. Open the clamp at the boom front end and remove the rope loop
from the retainer hook as shown in photo B6.
7. Extend the boom to its full length. The boom is set to the proper
length when the spring pins are in the “USE” position as shown below.
To lengthen, simultaneously press both spring pins and pull outward on
the tail of the boom until the pins snap into the USE position.
8. Next, Slide the boom upward from the bottom of the sail, threading the
sail through the space between the boom arms. The boom connects to
the mast through the lower cutout in the luff sleeve.
9. With the boom clamp open, pry the grip section open enough to
insert the mast. The grip section is designed to flex enough to
accomodate the mast.
10. Pass the rope loop around the back of the mast and over the
retainer hook. Before closing the clamp, position the boom roughly in
the middle of the sail’s lower sleeve cutout. See photo B10 on following
page.
B-6
B-7
B-9
B-8
