18
FINAL CHECKS AND SETUP
Position the lower unit into the slot on the set up board.
Using a small machinist rule (you can get one at your local
home store), adjust the engine so the distance between
the boat stand and the bottom of the cavitation plate are
30mm at the front and 28mm at the back. This will get you
close in both the height and tilt for your fi rst test runs.
Having completed this, remove one engine mount bolt
at a time and place some silicone sealer on the bolt and
re-install it. Do this with all 4 engine mount bolts.
Place the provided foam into the bottom of the radio
box and insert the receiver battery pack. Place the
receiver in the box as well. Do your best to place the
receiver so as not to stress the servo plugs.