AquaCraft Mini Rio, Руководство пользователя

Страница: 6 / 8

6
8 . Re-install the covers by aligning the tabs on the bottom of
the covers with the tabs in the openings. Rotate the covers
45° to secure them in place.
9 . Place the cowl on the boat and turn the front lock to hold it
in place. Your boat is now ready for operation.
POWER UP
It is important to follow the below sequence each time
you operate your boat.
POWER UP BEFORE A RUN:
1. Turn on the transmitter. Make sure the light on the top is
glowing red.
2. Plug in the 7.2 V battery pack. Turn on the receiver switch.
3. You will hear a faint “BEEP.” Fully squeeze the throttle
trigger and hold for 1 second. Again you will hear a faint
“BEEP”. Release the throttle trigger and wait one second.
You should hear two faint “BEEP-BEEP”s. Never during
the arming procedure push the throttle trigger forward.
Your boat is now armed and ready to operate.
4. Install the round hatch covers.
5. Install the canopy.
POWER DOWN AFTER A RUN:
1. Remove the canopy.
2. Remove the round hatch covers.
3. Unplug the 7.2V battery.
4. Turn off the transmitter.
5. Use a paper towel to remove any water that might have
entered the hull.
LAUNCHING AND DRIVING YOUR MINI RIO:
1. Place the boat in water that is at least 8” deep. Make sure
the water is free of weeds, sticks or other fl oating debris.
2. Slowly advance the throttle to get the boat a safe distance
from shore. Adjust the steering trim knob on your
transmitter until the boat tracks straight when the steering
wheel is at neutral.
3. Enjoy driving your MINI RIO!
4. When your boat starts to slow down, it’s time to drive it back
to shore. Typical run times are 6 to 9 minutes depending
on the charge and condition of your battery pack.
IMPORTANT: If your boat takes on a large amount of water
and stalls in the middle of the lake, don’t worry. Your Mini Rio
has foam fl otation so it will not sink. You will, however, have
to retrieve the boat and remove the hatch covers to remove
any water that might have entered the boat. If the inside of
the boat is fl ooded, remove the water and let the boat fully
dry before operating it again.
REVIEW:
Turn on transmitter.
Plug in battery, wait one second, “BEEP”.
Fully Squeeze Trigger, hold one second, “BEEP”.
Release Trigger, wait one second, “BEEP-BEEP” (do not
push forward).
Your boat is now ready to operate.