Aquacal AutoPilot SP05, Руководство по установке

Страница: 73 / 89

Page - 69
Displays "
NO POOL/SPA WATER FLOW
"
ISSUE
Low or no pool/spa water detected. This is normal when the circulation pump is deactivated.
RESOLUTION
1. Confirm the filter pump is on.
2. If a multiple-speed filter pump is being used, run at a higher speed to determine if the error persists. Do not
exceed the maximum flow rate for your model.
3. Confirm water is not being diverted away from the heat pump.
l
See " Water Flow Rates " on page 14.
l
See " Adjusting Water Flow Using ΔT (Delta-T) " on page 15.
Displays "
NO SOURCE WATER FLOW
"
ISSUE
Low or no source water detected.
RESOLUTION
1. Confirm the source water pump is on.
2. If a multiple-speed source water pump is being used, run at a higher speed to determine if the error persists.
Do not the exceed maximum flow rate for your model.
3. Confirm water is not being diverted away from the heat pump.
l
See " Water Flow Rates " on page 14.
l
See " Adjusting Water Flow Using ΔT (Delta-T) " on page 15.
Displays "
SET TO SWITCH REMOTELY
"
ISSUE
If when pressing the "Pool / Spa" button the display flashes the message "
SET TO SWITCH
REMOTELY
", the heat pump is using a remote relay switch or a 3-wire controller.
RESOLUTION
l
The Pool and Spa thermostat automatically switch when using these modes.
l
Operation manually will not be available when using these external devices. No action is required.
Displays "
SET UNIT MODEL NUMBER
"
ISSUE
The heat pump has encountered a software error.
RESOLUTION
l
The model number and serial number will need to be re-entered into the system. The system will then
operate as normal.
l
If the issue reoccurs, please contact AquaCal
®
Technical Support.
2
-
T
roubl
es
hoot
ing