Aquacal AutoPilot SP05, Руководство по установке

Страница: 19 / 89

Page - 15
MODEL SOURCE HEAT EXCHANGER TYPE
FLOW RATES
MINIMUM MAXIMUM
WS05
Source-Side
Titanium ThermoLink
®
20 GPM (75.7 L/min) 70 GPM (265 L/min)
Cupronickel 10 GPM (37.9 L/min) 18 GPM (68 L/min)
Pool / Spa Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
WS10
Source-Side
Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
Cupronickel 30 GPM (113.6 L/min) 54 GPM (204.4 L/min)
Pool / Spa Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
SunPower
MODEL SOURCE HEAT EXCHANGER TYPE
FLOW RATES
MINIMUM MAXIMUM
SP05
Source-Side Titanium ThermoLink
®
20 GPM (91 L/min) 70 GPM (265 L/min)
Spa Side Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
PLEASE NOTE -
If minimum flow rates are not met, heat pump performance is reduced and performance will
suffer. Internal safety devices may deactivate the heat pump with the following errors:
l
HIGH PRESSURE FAULT
l
HP5 SYSTEM LOCKOUT
l
LOW PRESSURE FAULT
l
LP5 SYSTEM LOCKOUT
l
Operate water filtration devices per manufacturer's specifications. Dirty filters can cause a reduction of water flow
to the heat pump. An increase of 7-10 psi (48 to 69 kPa) higher than the clean filter pressure typically reduces
flow rates. This requires the filter to be cleaned or back-washed.
l
Keep baskets free of debris. A large quantity of debris in the pump and skimmer baskets can reduce water flow.
l
Check for improper valve settings. A partially closed valve after the filter, or a full-open bypass around the heat
pump, will cause insufficient water flow through the heat pump.
l
The maximum static pressure (or operating pressure) is 50 psi (345 kPa) unless a special "high-pressure" unit has
been ordered. These specifications relate to the heat pump only.
l
Code-specified whole system turnover rates must be satisfied.
1.4.g Adjusting Water Flow Using ΔT (Delta-T)
The Delta-T is the temperature difference between the water temperatures entering and leaving the heat pump.
The equipment can be fine-tuned for maximum performance by balancing water flow rates to maintain an
ideal ∆T.
The adjustment procedure must be completed with the unit in heating mode.
PLEASE NOTE -
n
See " Temperature Port Kit (# STK0096) " on page 78.
1. Adjust the thermostat to its lowest setting with the unit in heating mode.
2. Deactivate the water filtration pump.
1
-
Ins
ta
lla
tion