product settings and troubleshooting
12ft / 4m
Midpoint of the Long side of Pool
Setting up the power supply is simple. First, make sure that the power supply
is plugged into a GFCI (Ground Fault Circuit Interrupter) outlet. Then lift the
cover on the power supply outlet and connect plug on the floating cable into
the power supply.
The power supply has
2 settings
. Each setting is determined by the pool
size and cleanliness as well as for how long you would like to run the cleaning
cycle.
You have an option for
sMAll pool
and
lArge pool
. Press the
select
button to get your correct setting
To turn the power supply
on
, press
and release the power button once.
To turn the power supply
oFF
, press
and release the power button. Light
will turn OFF
Cleaner
Power Supply
WArnings
product settings
poWer supplY
tiMer settings / pool siZe
WArning:
Do not turn the Power Supply on, unless the pool cleaner is in the water.
WArning:
Do not operate your machine while people swim in the pool.
WArning:
The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below.
WArning:
To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating current
not exceeding 30mA.
WArning:
Before performing any troubleshooting maintenance procedures, your Cleaner should be disconnected from the Power Supply (transformer) and
the Power Supply should be unplugged from the electrical outlet to prevent the possibility of personal injury or damage to your Cleaner!
= 1 Hour Shut-off
= 2 Hour Shut-off
= 1 Hour Shut-off
= 2 Hour Shut-off
Meijer.com
