product settings and troubleshooting
Your cleaner moves about your pool by way of an adjustable axle. This adjustable
axle is controlled by a slider that is located on the front of the cleaner. There are
various positions that this slider can be set to. Each setting will affect how wide
or tight the cleaner turns when running in it’s cleaning cycle.
It is recommended that before every cleaning cycle you alternate the position
so that the axle is cleaning the opposite way. This is so that your cleaner can
reach all areas of the pool and hence, prevents the cable from tangling.
Make sure the axles are freely moving and the axle channels are clear.
To set the preferred turning radius move the slider
either to the left or right . See the diagram below.
The slider is factory set to the
second setting from the center.
The E-Z Swivel is a feature that will help untangle the floating cable should
this occur. To use the E-Z Swivel it is recommended that you stand outside
of the pool.
Make sure that the floating cable is disconnected from the power supply!
Now grab the large part of the grip on the floating cable. Using one hand,
pull towards the direction that is between you and the power supply and walk
away from the cleaner. As you move further from the cleaner, the floating
cable will untangle itself and straighten out.
NOTE: It is recommended that you turn OFF the power supply before
entering the pool with the cleaner in the water.
Direction of
Power Supply
Direction of
Cleaner
product settings
AdJusting the AXle
hoW to use the e-Z sWiVel to help untAngle
FloAting cAble
Using E-Z Swivel while cleaner
is OFF and still
inside
pool
Using E-Z Swivel while cleaner is
OFF and
outside
pool
