5
ART-NTU-XUNIMPN000
–
Instructions for use and use Unikart Classic Motorized
UNIKART trolley for a
maximum of 136 kg.
1 – Maintenance and wearing parts
A
–
Maintenance to be done on the device
Regular maintenance is to be observed on your device:
Daily: - Check the correct operation of the roulette brakes.
- Check the good condition and proper operation of the electric cylinder.
- Check the battery charge, no audible "beep", meaning a battery below 20% capacity, when
connecting / raising the "red" stop button on the device.
Weekly: Visual inspection of the axes, cylinder and electrical cables which must remain clean, without
deformation, without leakage of oil or grease and without interruption in the electric cables.
Monthly: Check the good condition of the axes of rotation of the arms.
Annual: See the maintenance plan.
B
–
Security
Votre appareil doit être utilisé suivant une procédure décrite dans la partie correspondante.
De plus cet appareil doit également toujours être utilisé avec le respect de quelques notions
importantes et que nous indiquons ici regroupées :
•
The device must always be put in place with the brake pad unless there is a step of
more than 35mm high and at least 50mm from the edge of the basin justifying a
sufficient stop. The brake pad should be placed in alignment with the pond wall.
•
Before any use with a person, check that the battery is sufficiently charged, disengage
the push button, press the remote control, if a sound "beep" this product regularly, then the
battery is discharged to less than 20% of its capacity , do not use the device in this case and
put it in charge.
•
Never remove counterweights put in place at the factory or by a person authorized by
Hexagone.
•
If the
emergency
winch is used, in the event of a motor problem (and not a battery),
always wind up by turning the winch crank clockwise (unless the hexagon use of
reverse direction winch). When mounting it is imperative to hear the "click" of the
winch brake.
•
When using the
emergency
winch, never unroll the strap more than the red stop
mark.
•
Never use the device in case of deterioration on the axes holding the cylinder or the
cylinder itself.
