29/04/11
ADSP7000524 Rev.1
4 / 5
In fitting with the sleeve, after entering the lance in the hole, make downward pressure until the lance reaches the
bottom of the tank (Fig. 3)
.
In fitting with ring insert the spear into the hole, hand tighten the ring,
from inside the tank until the lance reaches the bottom of the tank (Fig. 4).
If the dosing pump is equipped with purge connect the pipe connecting the purge
of the junction block pipe.
The product will be well in excess channelled into the reservoir (Fig. 5).
Sondering for extracting connector ADSP6000454
In case you need to connect the lance throgh a connector,
you shoudl solder the cable on input 3 and 4 (see fig.6)
ADSP6000454
Maintenance
Check the upward mobility of float (Fig. 7).
&KHFNZLWKDPXOWLPHWHUWKHVKRUWFLUFXLWEHWZH
en the cables of the
probe when the float is low
&OHDQWKHILOWHUWKRURXJKO\ZLWKWDSZDWHU
and if necessary with compressed air.
After the implementation of the European Directive 2002/96/EU in the national legal system, the following applies:Electrical and electronic devices may
not be disposed of with domestic waste. Consumers are obliged by lak to return electrical and electronic devices at the end of their service lives to the
public collecting points set up for this purpose. Detalis to this are defined by the national law of the respective country. This symbol on the product, the
instruction manual or the package indicates that the product is subject to these regulations. By recycling, reusing the material or other forms of utilising
old devices, you are making an important contribution to protecting our environment
Fig. 3
Fig. 4
Fig. 5
Fig. 7
Fig. 6
Fig. 5
Содержание ADLASN
Страница 1: ...29 04 11 ADSP7000524 Rev 1 1 5 ADLASN OPERATING INSTRUCTIONS ...
Страница 2: ...29 04 11 ADSP7000524 Rev 1 2 5 ...
Страница 5: ...29 04 11 ADSP7000524 Rev 1 5 5 ADLASM ...
