Aqua A-POOL CHLORO HC997 CL-1C ADPCH34N, Руководство пользователя

Страница: 47 / 55

ADSP7000678 47 17/03/2016 Rev.0.1
P
ROGRAMMING MENU
– P
ROPORTIONAL FUNCTIONING
Press the keys to scroll
the menu entries.
Press the key to select the choice :
Functioning proportional chlorine Pt-Cu.
The pump doses proportionally by chlorine reading.
In this functioning, the parameters to set are the following:
Setpoint Cl
Indicates the Cl value to maintain constant.
Setting from 0,01 to 10,00 ppm at step of 0,01.
•
Prop. L1 Cl
Indicates the Cl value that together with the Setpoint value make
the proportional dosing band.
Setting from 0,01 to 10,00 ppm at step of 0,01.
% SPM Set
Indicates the dosing frequency of the pump at the Setpoint
value.
Setting from 0 to 100%.
% SPM L1
Indicates the dosing frequency of the pump at the Setpoint
value.
Setting from 0 to 100%.
Press the keys to adjust the measured value.
Calibration of Pt-Cu chlorine probe has 2 steps, Zero
Calibration and Gain Calibration.
The 2 steps can be done separately. At first you should make
Zero Calibration, later (even after some hours) you can
proceed with Gain Calibration
Zero Calibration Cal. CLF=0
To complete a correct Zero calibration you should use one of
the following procedures :
Procedure N° 1 – (Chemical Zero) Recommended
Close probe holder inlet valve, fill the probe holder from the
top of Pt-Cu electrode with local well water, wait
stabilization of reading (few minutes) than make adjustment
of value to 0 using one of the push bottom