background image

SECURING THE 

ANTENNAS

Once you have decided where 

to locate the unit you need to 

wrap the antennas around the 

pipe. It is normally easier to 

start by putting a plastic tyrap 

loosely around the pipe. Feed 

the end of an antenna wire 

through the tyrap and secure it 

so that there is the least amount 

of antenna left between the 

tyrap and the unit. The shorter 

this length of antenna, the more 

you have available to wrap round the pipe and the better 

the Aqua-Rex will work.

It is perfectly acceptable to allow the unit to hang 

below the pipe, suspended on tyraps or on its 

antennas. It does not need to be attached to a wall 

or hard surface.

Wind the remaining antenna around the pipe so that there 

are at least 12 turns, more if possible. Secure the other end 

of the antenna with another plastic tyrap. Repeat the process 

with the second antenna. Start it off in the opposite direction 

of the first antenna winding as shown in the picture above.

It is important that the antennas are wrapped 

around the pipe as tightly as possible. If they are 

loose the process doesn’t work. Do not use tape to 

secure the wires as the vibration from the flowing 

water will loosen the wires.

POWER SUPPLY

The Aqua-Rex requires a standard 120 volt outlet for the 

transformer. To reach a suitable outlet it may be necessary 

to extend the low voltage 9v AC power cable. Additional 

cable may be spliced in between the transformer and its plug. 

A waterproof seal should be made over the connections. 

Satisfactory tests have been conducted on a cable extension 

of 500 yards. The low voltage power supply is 9v AC so 

there is no need to be concerned about the polarity of the 

wires.

To protect the plug/socket from damp and rain, use the heat 

shrink tube supplied. Slide the heat shrink sleeve over the 

plug, connect it to the socket and use a hair dryer to shrink 

it into place.

PLUG / TRANSFORMER UNIT

Plug in the transformer and switch on the power supply. The 

LED on the unit will flash, indicating that the unit is powered 

up and that the program is sequencing through the range 

of frequencies.

HOW THE UNIT WORKS

Once the unit has been installed correctly on the pool 

circulation system it will pass a radio signal into the water 

which causes the calcium ions to precipitate in suspension in 

the water instead of on the surface of the pool.

Existing scale will also be removed over a few weeks and 

any staining will disappear with it. Some Silica scale may 

re-appear but it should be considerably less than previously.

Silica scale that has been leached from behind the tiles will 

not necessarily be reduced.

MAINTENANCE & TROUBLE SHOOTING

The Aqua-Rex needs no maintenance or servicing but do 

check occasionally to see that the LED light is flashing and 

that the wires are tight on the pipe. If the Aqua-Rex stops 

working, check first that the power supply to the transformer 

is functioning by plugging another appliance or lamp into 

the outlet and seeing if it works.

If the transformer is cold that means it has failed. 

Contact us for a replacement.

If the unit still fails to work, or you are not happy 

with the results, before you do anything else 

contact us by email or phone. 

Tel 702 304 2170 

[email protected]

Please do not remove the unit before contacting 

us. Very often the solution to the problem is very 

simple to resolve over the telephone or by email.

100 DAY MONEY BACK GUARANTEE

If, for any reason whatsoever, you are dissatisfied with your 

Aqua-Rex product, you may return it at any time during 

the first 100 days after purchase and the purchase price 

will be reimbursed in full. Simply return it to wherever it 

was purchased, together with your full name and address 

and proof of purchase, showing the price paid.

5 YEAR MANUFACTURER’S WARRANTY

Aqua-Rex LLC Guarantees that it will replace the WK1P 

unit should it suffer from a manufacturing defect during the 

first five years after the date of purchase. The unit should 

be returned to the dealer properly boxed & wrapped 

together with the invoice.

AQUA-REX LLC

3301 SPRING MOUNTAIN RD STE 18, LAS VEGAS NV 89102

T: 1-877 640 2170      E: [email protected]      www.aqua-rex.com

Отзывы: