4
J E T - V A C A U T O M A T I C P O O L C L E A N E R – I N S T A L L A T I O N & O P E R A T I N G I N S T R U C T I O N S
JET-VAC
AUTOMATIC
POOL CLEANER
2nd Section Dark Blue Hose –
4.2m (14ft)
CUT THIS SECTION ONLY WHEN
SHORTENING FEED HOSE
1st Section White Hose –
600mm (2ft)
3rd Section Light Blue Hose –
4.8m (16ft)
A
B
C
C
B
C
C
D
600mm (2ft)
Over
Measur
e
this
distance
A
= Bayonet Wall Fitting
B
= JVD5 Swivel
C
= JV57 Float
D
= JV52 Sweep Hose
FEEDER HOSE ASSEMBLY:
Feeder hoses are factory-assembled and must
always be in the following order:
FIRST SECTION
is a
WHITE HOSE
that fits
between the
WALL FITTING
and the
DARK BLUE
HOSE
.
SECOND SECTION
is a
DARK BLUE HOSE
that
fits between the
WHITE HOSE
and the
LIGHT
BLUE HOSE
.
THIRD SECTION
is a
LIGHT BLUE HOSE
that fits
between the
DARK BLUE HOSE
and the
JET-VAC.
The Jet-Vac feed lines are formulated with a special
material for maximum performance. These feed lines
cannot be kinked at any time either during operation
or when being removed from the pool. Kinking feed
lines will result in bursting and will not be covered by
warranty. From time to time it may be necessary to
lay the entire assembled hose out straight in the sun
to remove any coil-memory from the hose.
INSTALLATION PROCEDURE FOR
JET-VAC FEED HOSE:
1)
Turn off booster pump, filter pump and time
clocks.
2)
Attach the wall fitting to the pool wall, as shown in
Figure 1 on previous page. Feed hose is factory-
fitted to the wall fitting.
3)
Take the “sweep hose” end of the Jet-Vac hose
and walk around the circumference of the pool to
find the point that is furthest from the wall fitting.
Remove the slack from the hose but do not
stretch the hose.
4)
Hold the hose at the pool edge. Allow 600mm (2ft)
overhang past the pool edge, then measure from
this point to the end of the feed hose. Remember
what this distance is. This is the distance that will
need to be cut off the Dark Blue Hose.
5)
Go back to the Dark Blue Hose where it is marked
“Cut This Section Only”, unscrew the Mender Nut
and cut the hose to the required length. After you
cut the Dark Blue Hose, evenly space the Hose
Floats by sliding them so they divide the remaining
section into three equal parts. Depending on how
much hose is cut, there may be only one Hose
Float left on this hose. If so, then slide the Hose
Float to the middle of the Dark Blue Hose.
6)
Re-attach the Dark Blue Hose to the Swivel and
tighten the Mender Nut.
INSTALLATION PROCEDURE (continued)
