FILTER REPLACEMENT INSTRUCTIONS
1. Place towel under filter to collect any residual water during replacement filter change-out.
2. Grasp filter and turn to the left (counterclockwise) until filter comes to a complete stop (water automatically turns off).
Water may leak momentarily from vent tube. This is normal. Gently pull filter downward to remove.
3. Remove sanitary protective cap from new replacement filter.
4. Ensure both o-rings are present on the replacement fi lter and are seated into grooves; moisten o-rings with water.
DO NOT use any petroleum products to lubricate the o-rings.
5. Insert replacement filter into filter head assembly. Turn replacement filter one quarter turn to the right (clockwise)
until it stops. When fully engaged, the top surface of the filter will be flush with the bottom of the filter head assembly.
(See Figure 6)
6. Open faucet and run water for a minimum of 4 gallons (approximately 2 minutes). While system is flushing, check for
leaks. Repair any leaks as needed before continuing.
Close filter system faucet. System is now under pressure and can be inspected for leaks. Repair any leaks as needed
before continuing. The system is now ready for use.
CAUTION
To reduce the risk associated with property damage due to water leakage:
•
The disposable replacement fi lter
must
be replaced every twelve (12) months, at the rated capacity or sooner
if a noticeable reduction in fl ow rate occurs.
Figure 6
INLET
OUTLET
12. Align lugs of filter with head assembly and insert filter into
head assembly. Turn filter to the right (clockwise) until it stops
(about 1/4 turn). The filter is now installed. (See Figure 6)
13.Turn on cold water supply valve and open faucet to flush air
from the system. Run water for a minimum of 4 gallons (ap-
proximately 2 minutes) to flush system.
14. Close the faucet. The system is now ready for use. System
is now under pressure and can be inspected for leaks. Repair
any leaks as needed before continuing.
TROUBLESHOOTING GUIDE
Water Leaks at Push-In Connections:
Push tubing in as far as it will go. If leaking continues, shut off water at the cold water supply valve and remove
water line by pushing in on the connector collar while pulling the tubing away. Inspect tubing for cracks and
scratches. If tubing is cracked or scratched, simply cut that portion away and reinsert tubing into push-in fitting.
Make sure tubing is cut straight. If not, recut correctly. Please refer to Figure 4.
If water leaks, please verify that the o-rings are properly seated in their grooves.
Water Does Not Flow From The Faucet:
Check to see if the main water line valve is open, allowing water to fl ow to the fi lter. Make sure the con-
nections are not reversed.
Water Appears Cloudy or Air Comes Out of the Faucet:
Flush 4 gallons through system before use (approximately 2 minutes).
4
INSTR2214 1011.indd 4
10/24/2011 9:49:48 AM
Содержание 3MFF100
Страница 2: ......
