15
TURNING ON THE HEATER MANUALLY- MAINTAINING HEAT
Ensure the spa is in Active Mode.
Press the
button to adjust the temperature to the desired temperature.
Press this
button to turn on the heater manually.
You will see the word heat flashing on the touchpad, once the heat word goes solid and stops flashing the
spa is heating. If you leave the spa in active mode and leave this button turned on permanently it will
maintain the set temperature within 3 degrees. For example, if you set the spa to 38 degrees it will take the
spa to 38 degrees automatically turn off and when the spa drops 2 to 3 degrees in temperature it will turn
back on and re heat the spa to 38 degrees. If the head word in not flashing or solid on the touch pad the
button has been turned off and will need to be re pressed to turn this feature back on.
TURNING ON THE HOT WATER MASSAGE PUMP
Ensure the spa is in Active Mode.
Press this
button to turn on the hot water pump.
To turn off the hot water pump press the same button again.
This pump will automatically turn itself off after a set amount of time running, if it turns off while you are
in the spa you can press the same button to make it run again.
TURNING ON THE AIR BLOWER
Ensure the spa is in Active Mode.
Press this
button to turn on the air blower.
To turn off the air blower press the same button again.
This air blower will automatically turn itself off after a set amount of time running, if it turns off while you
are in the spa you can press the same button to make it run again.
TURNING THE WATERFALL ON & OFF
The waterfall will only run whilst the spa is heating once the desired heat is reached the waterfall will
not run. When using the waterfall handle do not apply pressure to the handle at the fully open or fully
closed positions you will break the handle if you do.
To run your waterfall, turn the manual – maintaining heat button on and set the temperature button at
least two degrees above the current water temperature.
Press the
button to adjust the temperature two degrees higher that the current temperature.
Press this
button to turn on the heater manually.
Now turn the waterfall control handle anticlockwise to run the waterfall. To turn the waterfall off turn the
waterfall control handle clockwise until the waterfall stops running. Reduce the temperature button
back to the original temperature. Make sure you turn the waterfall control handle to the closed position
when you finish using this feature. If you the leave the waterfall handle in the open position the spa will
leak water when the hardcover is on the spa.
TURNING THE LIGHTS ON & OFF
