Aqua Pulse Spas Noosa Luxury, Руководство пользователя

Страница: 21 / 23

21
When using this handle do not apply pressure to the handle at the fully open or fully closed positions you
will break the handle if you do.
To run your waterfall turn the manual heating button on and set the temperature button at least two degrees
above the current water temperature, then turn the waterfall control handle anticlockwise. To turn the
waterfall off turn the waterfall control handle clockwise until the waterfall stops running. Reduce the
temperature button back to the original temperature.
AIR CONTROL HANDLE
The air control handle can be located on the spa image on page one.
This handle controls the amount of air pressure coming from the jets, which will increase the water
pressure if it is turned anticlockwise and will decrease the water pressure if it is turned clockwise.
MAIN WATER DIVERTER
The main diverter handle can be located on the spa image on page one.
Do not turn this handle while the pumps are running and do not apply pressure to the handle at the fully
open or fully closed positions you will break the handle if you do.
This handle is used to divert the water within the spa, when you turn the handle to different positions the
water pressure will change within the spas chairs. This handle will make noise when the pumps are
running, and the noise level will vary depending on where the handle is positioned.
AROMATHERAPY CONTROL HANDLE
Your spa has an inbuilt aroma therapy stick which can be located on the spa image on page one. With all
the pumps turned off unscrew the fitting from the spa and take out the stick. Remove the plastic transport
cover by unscrewing the blue cap and sliding the opaque cover off to expose the scented stick inside,
screw the blue cap back onto the aroma stick leaving the opaque cover off. Reinstall the stick back into the
spa, do not overtighten the fitting it only needs to be lightly tightened. Turning the handle clockwise runs the
aroma scent when you have the air blower turned on and turning the handle anticlockwise will turn the
aroma scent off.
MY SPA IS TOO HOT IN SUMMER, THE TEMPERATURE OF THE WATER IS HIGHER THAN I HAVE
SET
During summer there may be times when the spas water exceeds the set temperature. This is not a fault in
the spa it is simply the ambient air temperature causing this. To combat this problem, you can use ice to
cool down the water.
FROST PREVENTION SYSTEM
If the temperature of the spas water drops below 5°C the spa will switch on the heater until the spa
reaches the temperature of 8°C.
OZONATOR
The spas ozonator will automatically turns itself on and off when required, there are no adjustments you are
able to make.