Aqua Power DH 100, Инструкция по эксплуатации и монтажу

Страница: 6 / 14

Technical Data
Symptom Cause Solution
No hot water - water flow too low to activate
flow switch.
- shower head is blocked with dirt
or lime
- circuit breaker off
- safety thermal cut-out tripped - increase flow volume
- clean shower head or remove
lime scale
- turn breaker on
- reset thermal cut-out
The unit is not being switched on, elec-
tric supply and flow available - the minimum flow to activate unit
has not been achieved.
- filter in cold water connection
line blocked - increase flow volume
- clean the filter screen after
shutting of the cold water supply
Water not hot enough - water flow too high
- heat setting too low - reduce water flow
- turn temperature control knob to
the right (max. position)
Troubleshooting
Model
1
DH 60 DH 80 DH 100 DH 100 C
Item No.
227259 227329 234029 234030
Design
Pressure type
Current
Single phase - 60/50
Hz
208 V
9.36
kW
/ 45
A
220 V
5.5
kW
/ 25
A
7.3
kW
/ 33
A
8.4
kW
/ 38
A
Not available
230 V
6.0
kW
/ 26
A
8.0
kW
/ 35
A
9.2
kW
/ 40
A
Not available
240 V
6.5
kW
/ 27
A
8.7
kW
/ 36
A
10.0
kW
/ 42
A
Not available
Recommended circuit
breaker size
2
30
A
40
A
50
A
50
A
Wire gauge, copper
3 10
AWG
8
AWG
6
AWG
6
AWG
Minimum water flow to
activate unit
0.76–0.92
gpm
2.9–3.5
l/min
0.85–1.0
gpm
3.2–3.8
l/min
0.92–1.1
gpm
3.2–4.0
l/min
0.92–1.1
gpm
3.4–4.0
l/min
Minimum water pressure to
activate unit
3
psi
/ 0.2
bar
4.4
psi
/ 0.3
bar
4.4
psi
/ 0.3
bar
4.4
psi
/ 0.3
bar
Max. working pressure
150
psi
/ 10
bar
Volume of water in unit
0.13
gal
/ 0.5
l
Weight
3.44
lb
/ 1.56
kg
Dimensions
(H x W x D)
13
¾
” / 350
mm
x 7
¼
” / 210
mm
x 3
¾
” / 100
mm
Plumbing connections
G ½”
1 Suitable for supply with cold water
2
This is our recommendation as the manufacturer. Check local codes for compliance if necessary. Tankless water heaters are considered a non-continuous load.
3
Copper must be used. Conductors should be sized to maintain a voltage drop of less than 3% under load.
WARRANTY
Make any warranty claim in the country where you purchased the appliance. In such cases, please contact our representation
or the importer.
Our warranty applies only if:
– These installation instructions have been observed
– Exclusively accessories designated for this appliance have been used
– All required steps up to and including commissioning have been carried out by a qualified contractor
– Maintenance as specified has been carried out
– Exclusively our spare parts have been used for repairs
Environment and recycling
Please help us protect the environment. Dispose of the appliance and its packaging in accordance with national regulations.