Aqua One AirO2Pod 240, Руководство пользователя

Страница: 2 / 5

2 3
Remember to arrange a drip loop (see graphic).
14. If you are in any doubt about the electrical installation or
safety of this product you must consult a qualified electrician.
15. The supply cord must not be repaired or replaced. If it is
damaged, replace the entire pump unit.
16. Turn the pump off and remove the air filter. Clean or replace
as necessary on a regular basis.
Read and follow all the instructions, even if you feel you are
familiar with the product and find a place to keep the instructions
handy for future reference. Your attention is drawn particularly to
the sections concerning “IMPORTANT SAFEGUARDS” and the
“GUARANTEE CONDITIONS”. Please ensure you retain your
original purchase receipt in the event that guarantee service is
required.
Carefully unpack the product making sure you keep all the
packing material until all the parts of the product have been found
and the product has been assembled.
This product was packaged in excellent condition in the factory.
Should you find that the product is damaged, has been dropped,
or malfunctions in any way, contact the retailer where the product
was purchased, for inspection. Please insure you retain your
original purchase receipt in the event that warranty service is
required.
Before First Use / Preparation
Important Safeguards
To guard against injury, basic safety precautions should
be observed, including the following:
1. Read and follow all safety instructions and important
notices in these instructions as well as on the product itself.
2. This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved.
Children shall not play with the applicance.
Cleaning and user maintenance shall not be made by children
without supervision.
3. To avoid possible electric shocks, special care should
be taken since water is employed in the use of aquarium
equipment. For each of the following situations do not attempt
repairs yourself. Return the appliance to an authorised service
facility for service or discard the appliance.
a. If the appliance or any electrical component of the appliance
(non-immersible equipment only) falls into the water or gets
wet, do not reach for it. Unplug it and then retrieve it.
b. If the appliance shows any sign of abnormal water leakage,
immediately unplug it from the power source
c. Carefully examine the appliance after installation. It should
not be plugged in if there is water on parts which are not
intended to be wet.
4. If you wish to use the pump above the water level of the
aquarium, it should be fixed by screw (d. Mounting Point) to a
solid surface (except Stellar 50).
5. Always unplug the appliance from the electrical outlet
when not in use, before putting on or taking off parts, before
any type of maintenance or cleaning.
6. Never yank the cable to pull it from the socket. Pull the plug
carefully to disconnect.
7. Do not use the appliance for reasons other than the intended
use. The use of attachments that are not recommended or
sold by the manufacturer may cause the product to be unsafe.
This is not recommended.
8. Do not install or store the appliance where it will be exposed
to weather or temperatures below freezing.
9. Make sure any component mounted on a tank is securely
installed before operating it.
10. Ensure input voltage is the same voltage as your local
power supply.
11. If an extension cable is used it should have the proper
rating. Care should be taken to arrange the cord so that it will
not be tripped or pulled.
12. A G.F.C.I (Ground fault circuit interrupter) & surge protector
is recommended for all electrical appliances.
13. Ensure your hands are dry, plug the pump in and turn on.
All products are supplied with fitted plugs. This plug should not
be tampered with in any way or removed. Removal or tampering
with the plug invalidates our guarantee offered with this product.
For UK a 3 pin adaptor is supplied with the product and this must
be used.
Air Stone:
• Replace the air stone every 6 months or when it
shows signs of deterioration.
• If being used in salt water a plastic or ceramic air
stone is recommended.
Hints & Tips for Best Results Know your pump
Step by step guide
1. Decide where you are going to position the air
pump. Remember the pump must remain accessible for
maintenance.
2. Where possible place the pump above the aquarium. Avoid
placing the pump on a carpeted surface.
3. If this is not possible then ensure that a check valve is fitted
to the airline, failure to do so will damage your air pump & void
your Guarantee. Ensure the check valve is inserted correctly.
They only flow one way. Refer to diagram.
4. It is best to position the check valve as close to the aquarium
as possible, as shown in the picture below.
5. Attach one end of the air line into your ornament or air
stone.
6. Attach the other into the outlet of your pump.
7. Position your pump. Ensure it is not going to vibrate off what
ever surface you place it on.
8. Ensure your hand is dry, plug the pump in and turn on.
Remember to arrange a drip loop.
a. Air outlet
b. Rubber feet
c. Air filter
d. Power cord
e. Screws
Always ensure the power cord is not plugged in when
maintenance is being carried out on the pump.
a
b
c
d
e
Air In