Aqua-Marina X series, Руководство пользователя

Страница: 8 / 14

Motor
8
1. Tilt Position Lever - This lever allows the user to adjust the tilt (angle) of the motor. Push tilt position
lever, adjust tilt of motor, release lever.
2. Steering Tension Adjustment -To adjust the steering resistance, simply tighten or loosen the tension
knob located on front of the mount.
3. Depth Adjustment Collar -The depth of the motor can be adjusted up and down by loosening the
depth collar tension knob located on the column directly above the mount. The column can be
adjusted and the motor can be positioned at the desired depth by retightening the tension knob.
4. Transom Screws -The transom clamp screws allow for easy motor removal and installation. Mount
your motor on the transom then tighten the transom clamp screws securely.
HOW TO REPLACE THE PROPELLER
Hold the propeller blade and loosen the propeller nut using the prop spanner supplied or a set of
needle nose pliers. Remove the propeller nut. Pull the propeller straight off. If prop is stuck, grasp one
blade with one hand and tap on the backside of the opposite blade lightly with a rubber mallet, until
the propeller comes off. If the propeller pin is bent, replace it. Align the new propeller with the
propeller pin. Reinstall the propeller nut and tighten firmly by hand, tighten with spanner another 1/4
turn.
Step 1 Step 2 Step 3
The motor can only be used in water deeper than 0.7m.
Make sure that the motor has been disconnected from batteries.