5
AquaGuard | DualFlo
Technical Data
Model
HP
RPM
Volts / Hz
Amps
Motor Length (L)
DF102S
1.0
3450/1720
115V/60
10/3.2
11.9"
DF102STL
1.0
3450/1720
115V/60
10/3.2
11.9"
DF152S
1.5
3450/1720
115V/60
12/3.6
12.2"
DF152STL
1.5
3450/1720
115V/60
12/3.6
12.2"
Maintenance
Water Chemistry
A proper and consistent use of chemicals is necessary to maintain clean, sanitary water, prevent a spread of germ infection and
control the growth of algae which can spoil the appearance and enjoyment of your pool or spa.
Chlorine is the most commonly used chemical to provide clean, sanitary water. Either dry or liquid chlorine (calcium or sodium
hypochlorite) can be used which should be added daily as it is dissipated by dirt and germs as well as be the sun and wind.
It is also important that the correct level of acidity or alkalinity of the pool water be maintained. This is the pH of your pool with pH
7.0 being neutral. Readings above 7.0 are alkaline and below are acid. A desirable range is 7.2 – 7.4.
Pump Maintenance
1. Motors are self-lubricating – no lubrication required.
2. Clean hair & lint strainer if you have a strainer body pump.
3. Visually inspect motor for blockage of air vents on motor shell. Remove any debris after breaker off.
4. Shaft seals may become worn and must be replaced if leakage is observed.
Cleaning
Switch power off. Close valves in suction and return line. Unscrew strainer Ring-Lok counterclockwise and remove the strainer
cover from hair and lint strainer and lift out strainer basket. Clean and replace the basket. Take care to seat basket properly. Clean
O-Ring and re-lubricate with petroleum jelly if necessary. Clean O-Ring seats on cover and strainer. Refit cover and strainer – hand
tighten only – and open valves. Put pump back into operation.
CAUTION:
Do not re-tighten strainer during operation.
Service & Repair Parts
Refer all service to your local dealer as his knowledge of your equipment makes him the best qualified source of information.
Order all repair parts through your dealer. Give the following information when ordering repair parts:
1. Unit nameplate data.
2. Description of part.
L
9.76"
13.78"
3"
7.75"
10.31"
6.50"
4.88"
9.92"
6.67"
