AQUA FORTE SC997, Руководство пользователя и обслуживания

Страница: 10 / 16

7
III. Installation Instructions
WARNING: Installation must be carried out by a qualified engineer.
This section is provided for information purpose only and must be checked and adapted if
necessary according to actual installation condition.
1. Pre-Requirements
Needed equipment for installation of heat pump:
Suitable power supply cable for unit’s power.
A by-pass kit and an assembly of PVC tube, stripper, PVC adhesive and sandpaper.
A set of wall plug and expansion screw.
We recommend to use flexible PVC pipe in order to reduce transmission of vibration.
Suitable fastening studs may be used to raise unit.
2. Location
Please comply with the following rules about heat pump location choosing.
1. The unit’s location must be convenient for operation and maintenance in the future.
2. It must be installed and fixed on flat concrete floor. The floor is stable to support the weight of the
unit.
3. A water drainage device must be provided close to the unit in order to protect the area where it is
installed.
4. If necessary, mounting pads could be used to support the weight of unit.
5. Confirm the unit is under well-ventilated condition; air outlet port is not facing to the windows of
nearby buildings and the outlet air can not be returned. In addition, provide enough space around the
unit for repair and maintenance.
6. The unit must not be installed in an area exposed to oil, flammable gases, corrosive products,
sulphurous compounds or close to high frequency equipment.
7. To prevent mud splashes, do not install the unit near road or track.
8. To avoid noise to neighbours, please make sure the unit is installed in less noise sensitivity area
or good sound isolation area.
9. Keep the unit as far as possible away from children.
10. Installation space