Aqua Creek Products F-SCTXL, Руководство пользователя, Страница: 6 / 15

FIG. 05
5 THE SEAT ASSEMBLY WILL ARRIVE ATTACHED TO THE
SEAT POLE ADJUSTED TO ITS HIGHEST POSITION (HOLE 05).
TO ADJUST THE SEAT ASSEMBLY TO A LOWER POSITION
REMOVE THE FASTENERS SHOWN IN FIG. 05. SLIDE THE
SEAT ASSEMBLY TO ITS DESIRED POSITION (4"
INCREMENTS) AND REINSTALL THE FASTENERS. THE
MAXIMUM ADJUSTMENT IS 16"
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THE
BOTTOM TW0 HOLES-ALWAYS USE THE TWO (2) SUPPLIED
BOLTS TO ATTACH THE SEAT ASSEMBLY TO THE SEAT POLE!
NOTE: FOR MOST APPLICATIONS THE SEAT WILL BE
INSTALLED IN ITS LOWEST POSITION (HOLE 01). FOR
APPLICATIONS WHERE A WALL OR CURB MUST BE CLEARED
THE SEAT SHOULD BE INSTALLED IN A HIGHER POSITION.
HOLE 05
HOLE 04
HOLE 03
HOLE 02
HOLE 01
FIG. 06
6 THE AQUA CREEK FOOTREST ASSEMBLY IS DESIGNED
TO FIT UNDER THE CHAIR AND IS INSTALLED INSIDE THE
2" SQUARE TUBING THAT SUPPORTS THE SEAT FROM
UNDERNEATH. TO INSTALL THE FOOTREST; FIG. 06
6 A INSERT THE FOOTREST ASSEMBLY INTO THE 2X2
SQUARE TUBING THAT SUPPORTS THE CHAIR UNTIL THE
PLASTIC INSERT OF THE FOOTREST ASSEMBLY SITS FLUSH
AGAINST THE END OF THE 2X2 TUBE.
6 B USING THE SUPPLIED
1/4" FASTENERS, FASTEN THE
LEG REST ASSEMBLY TO THE
2X2 TUBING IN THE DESIRED
LOCATION.
Aqua Creek Products
PRODUCT ASSEMBLY
6/27/2022 8:55:18 AM PAGE - 6