Copyright © 2019 Aqua Creek Products All Rights Reserved
Revised 6/18/19
Patriot-AT1 Fixing Kit Installation Instructions
1.
Determine the location of the
anchor insert, allowing for the ADA
compliant clear deck space. (see
FIGURE 1, page 3)
2.
Mark the location for the 1-1/4
inch x 4 inch deep anchor hole.
Using a core-drill, drill a 1-1/4 inch
diameter, 4 inch deep hole at the
marked location.
3.
Dry-fit the anchor insert to make
sure it fits flush with the deck
surface.
4.
Fill the hole 1/2 full with epoxy (or
equivalent). Install the anchor insert
flush with the deck surface and
clean off any excess. Allow 24 hours for the epoxy to cure.
5.
Roll the portable cart over the installed anchor. Align the anchor with the fixing bar.
6.
Drop the fixing bolt into the fixing bar and, by hand, start to thread into the anchor
insert. If needed, adjust the alignment of the lift.
7.
When properly aligned, complete threading with a 3/4 inch wrench or socket.
Tighten until the bolt just touches the flat washer. DO NOT OVERTIGHTEN.
TOOLS REQUIRED:
• Core-drilling rig
• 1-1/4” diameter core-drill
• 3/4” wrench or socket
• 2-part construction epoxy or equivelent
• Tape measure
• Marking pen
FIXING BOLT
( 1/2-13 X 4-1/2")
1/2" FLAT WASHER
PVC ANCHOR INSERT
BRAKE FOOT
NOTE: Fixing Kit installation is only required for ADA applications.
7