Aqua Comfort ACT1100, Руководство по установке

Страница: 9 / 32

Water Flow & Connections
Water connections are made at the rear of the heat pump opposite the control panel. Water “in”
and “out” are labeled at the connections. Unions are supplied and are made to accept either 2”
or 1 ½” rigid PVC pipe. See Model Specifications table (page 3) for required flow rates.
NOTE: Unions can be used for quick drainage of your heat pump and winterizing.
•
Heat pump must be piped downstream from the filter in the pool return line.
•
When all the plumbing connections are complete, and ample drying time is allowed for
the glued connections, run the filter pump and check the entire system for water leaks.
•
Make sure filter is clean and there are no obstructions in the filtering system.
•
Proper water flow is essential to the performance of the heat pump.
•
The minimum flow rate is 20 GPM.
•
Use proper PVC cleaner, PVC glue, and proper gluing
techniques when making PVC pipe connections.
PLUMBING REQUIREMENTS
CAUTION - Failure to heed the following may result in equipment damage.
•
Do not use glue on the threaded portion of the equipment’s unions.
Gluing a union in place will prevent the ability to service or winterize the unit.
•
The heat pump must receive water flow within the specified ranges in all conditions.
Water flow exceeding maximum flow rates may damage heat pump and will not be
covered under equipment warranty. See Model Specifications table (page 3) in previous
section for water flow rate ranges based on unit.
8 ACS XL Heat Pump Pool Heater Installation Manual
FIGURE 5.1: SINGLE HEAT PUMP & POOL