Pivoting Extension Boom
11
11/279
B
C
DÉTAIL B
DÉTAIL C
-
12-04-2022
Masse = 329 Lbs
EBS-1010
-
12-04-2022
TOLERANCES:
.x = 1/8
.xx = 1/16
.xxx = 1/32
Échelle:1:32
Ce dessin est la propriété de
Aireau Qualité Contrôle et ne
peut en aucun cas être copié ou
manipulé sans le consentement
de la direction.
FEUILLE NO : 1 OF 1
Modifié par :
Dessiné par :
DATE
NOM
Les dimensions sont en pouces et
sont extérieures sauf sur indication
contraire.
Ne pas mesurer directement
sur le plan
REV.
DESSIN NO.
NOM DU PROJET :
MS-EBS-1010
MODEL DE VOLET:
AQC-SSIDHP
10 .
Insert tie rod end section of pull rod into boom base
pull rod support bracket and attach with fastener.
Replace last nut and washer onto threaded end of
pull rod.
Note:
At this point, do not try to adjust and level the
horizontal support beam. Wait until optional equipment at
end of swing boom has been installed.
11 .
Using the hose clamps supplied, fasten flexible hose
from spiral pipe section to boom base flexible hose
flange.
9.2.2 Assembly (middle pivot, if ordered)
1.
Remove friction disks and fasteners from horizontal
steel tube middle pivot bracket.
2.
Slide middle pivot assembly into pivot bracket.
3.
Insert (1) friction disk (#10) over and under the pivot
section.
4.
Using a spike, align holes of friction disks to pivot
assembly, ready for fasteners insertion.
5 .
Insert bolt and washer from the top of assembly
and attach with nut and washer underneath pivot
assembly.
6.
Using the hose clamps supplied, fasten flexible hose
from spiral pipe section to middle section.
9.3 Connection of boom base to exhaust
ductwork
MAXIREACH
extension swing booms are supplied with
one (1) duct companion flange. By factory standards,
companion flange is installed on the upper (top) part of the
boom base. Field modification to have companion flange
installed at the bottom is as follows;
1.
Remove duct companion flange from upper boom
base section
2.
Remove boom base cover plate from lower boom
base section
3.
Install duct companion flange on lower boom base
section
4.
Install boom base cover plate on upper part of boom
base.
