AQC MAXIHYDRO MS, Руководство пользователя

Страница: 7 / 14

Wet type dust collector
7
5 CHECK THE UNIT
Check to ensure that the inspection window, located at the discharge end of the unit is tightly
bolted.
6 THE FAN
(IF PART OF SCRUBBER)
Fit the fan to the outlet end of the collector. For the best performance of the fan, the length of
straight duct between the unit discharge and the fan inlet should be five times the inlet diameter.
Check that the fan is correctly installed and is firmly sealed.
Trial start fan to ensure that the rotation of the blades is correct, and that there is no vibration.
7 SET UP THE WATER SYSTEM
Connect water pipe to the unit’s water control system. Check the water pipes by trial running water
through them, and tightening joints if necessary.
8 GENERAL INFORMATION
When the unit is operating the unit will be supplied. For sludge removal, the unit is supplied with a
sludge rake-out chute, for sludge removal, bring a container or dump truck under the chute, open
the rake-out door, use the supplied rake and slowly reach into the tank, pull the rake towards the
chute and continue up the slope and discharge sludge into the container, continue until the floor
seems free of sludge, remove container, replace rake-out door. Unit is ready to operate.
WARNING!
Once the water control system has been set correctly the
system should not be re-adjusted. This unit will give constant
efficiency and air flow.
WATER FILL VALVE