5
Common Malfunction and Solutions
Malfunction
Reasons
Solutions
(Please cut off power
before any operation)
The engine doesn’t
work after the power
is on
Poor power contact or
power cord is loose
Replace the power
supply or socket
LCD time display doesn’t
work
Plug in and press the
overload protector, at
least 5 minutes later try
again.
Carbon brush doesn’t
contact with the engine
or is badly worn
Reset or replace carbon
brushes
The engine makes a
buzzing noise after
electrify and blades
turns slowly or even
doesn’t work
Low voltage
Adjust the power supply
voltage
The wet or excessive
materials stop blades
working
Cut off power
immediately ( prevent
the engine from burning
out ) and remove the
stuck object
carbon brush or blade
seriously worn
Change the carbon
brush or blade
The engine surface is
overheated and the
stop working
Running time too long
Reduce the work hours
Excessive load
Reduce material quantity
The engine is damp
Dry the engine
Attention and Warnings
WET INGREDIENTS SHOULD BE DRIED FIRST BEFORE CRUSHED
PAY ATTENTION TO THE FOLLOWING MATTERS
1. Please check the product and all accessories first after removing the package.
Please contact APWONE Service Center if there’s anything wrong.
2. Make sure the voltage used is the same as the rated voltage on the nameplate
before use.
3. Children are prohibited from using it without supervision.
4. Be very careful when you remove the blade or clean the machine.
5. Materials shall not exceed 2/3 of the storage capacity in smashing body. It is
forbidden to be overfilled or over released.
