APW Wyott TBTGDL, Инструкция по установке и эксплуатации

Страница: 6 / 16

Procedure ( Daily):
1. Turn off Grill and allow time for cooling. NOTE: DO NOT add ice or water to the Grill surface to
accelerate cooling, this can damage the platen. Allow time for platen to cool.
2. Dampen a cloth with soapy water and or Sizzle.
3. Apply the damp cloth to the platen and stainless steel trim, but do not pour soapy water onto platen
surface.
NOTE: Typical cleaning should require small amount of non-abrasive cleaner.
4. Apply adequate pressure to the damp cloth to remove soil; hard scrubbing is not necessary.
5. Wet a clean towel and ring out the excess water in sink or bucket.
6. Wipe platen surface with damp towel to remove left over soap, sizzle and soil from platen surface
and stainless steel trim.
7. Rinse the towel and wipe the platen surface again until platen is absolutely clean.
TROUBLESHOOTING
Always ask and check the following:
Not getting power:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the rating label. Is the unit connected to the correct power source?
3. Check the circuit breaker.
4. Is power switch “ON”?
5. If the above checks out, and you still have problems, call your local service agent.
6