GENERAL INFORMATION
I.
Consult the rating label for model and serial number. Write this information below before
proceeding:
A. Model # __________________
B. Serial # __________________
II.
Overall Dimensions w/Wire Feeder - 16.1" H (409mm) x 15.2" W (385 mm) x 22.8"D (579mm)
III.
Product Opening - 3.0" H (76mm) x 10.50" W (267mm)
IV.
Productivity (per hour) - results will vary depending on line voltage and bread dryness.
V.
Electrical Requirements
A. Single phase, 208-240 volts, 2850 watts, 13.7 amps.
B. Cordset configuration
1.
Each toaster is equipped with a three-wire grounded cordset and standard three-prong
plug.
2.
In the United States, a four foot cordset with NEMA 6-20P plug.
3.
In Canada, a six foot cordset with NEMA 6-20P plug.
Net/Shipping Weight - 44Ib.(20.0kg) /52Ib.(23.4kg)
INSTALLATION INSTRUCTIONS
I.
Check Contents - refer to Figure 1, account for the following parts:
A.
Toast Drawer - shipped in place
B.
Reflector Tray - shipped in place
C.
Wire Feeder - inside Reflector Tray
D.
Instruction Manual - shipped loose
NOTE: DO NOT OPERATE THE TOASTER WITH THE REFLECTOR TRAY REMOVED FROM
ITS POSITION
II.
Position Wire Feeder - refer to Figure 2
A.
Pull out Reflector Tray
B.
Rotate Wire Feeder
C.
Slide Reflector Tray back
D.
WARNING: Operating the toaster without the Reflector Tray reduces toasting capabilities.
!
!
WARNING:
Genuine APW Wyott Replacement Parts are specified to operate safely in the
environments in which they are used. Some aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely in APW Wyott equipment. It is essential to
use APW Wyott Replacement Parts when repairing APW Wyott equipment. Failure to use APW
Wyott Replacement Parts may subject operators of the equipment to hazardous electrical voltage,
resulting in electrical shock or burn.
!
CAUTION:
Locate the unit at the proper counter height, in an area that is convenient for use. The
location should be level to prevent the unit or it’s contents from accidentally falling, and strong
enough to support the weight of the unit and food.
!
!
!
CAUTION:
The National Sanitation Foundation (NSF) requires that units over 36” (91 cm) in length
or weighing more than 80 lbs. (36 kg) to be either sealed or raised on the installation surface. If this
unit cannot be sealed at the point of use, 4” (10 cm) legs are included to allow for proper cleaning
access below unit.
!
!
WARNING:
Failure to provide clearances will cause unit failure and invalidate warranty claims
(see installation instructions).
4
figure 2