background image

4

5. TROUBLESHOOTING

Always ask and check the following:

1.

Is the unit connected to a live power source of the proper voltage?

2.

Check the circuit breaker.

3.

Is power switch “ON” and lights glowing?

4.

Check the rating label. Is the unit connected to the correct power source?

5.

If the above checks out, and you still have problems, call your local service agent.

4. CLEANING INSTRUCTIONS

Warning

Warning

:

Before cleaning, ensure that the unit is unplugged and its components are cooled down. There should be no

power going to the unit.

:

Never spray water on the unit or controls nor submerge unit in water. Damage to the unit as well as injury

could occur. Injury and burns may occur if you do not follow this instructionsheet.

Unplug Power

Cleaning

Cleaning should be done Daily.

1.

Clean outside with warm soapy water and a soft cloth only. Mild degreaser can be used. Do not use

abrasive cleaners, as they will scratch the finish, which could induce dirt accumulation.

2.

solvents or acetone type cleaner. They will damage the sealant.

3.

Once a week, clean the inside of the cabinet with warm soapy water and a soft cloth only. Mild

degreaser can be used.

DO NOT USEANY

3. OPERATION INSTRUCTIONS

1.

The On/Off switch should be in the offline position “0”.

2.

Flip switch to online position “I”.

:

The unit's external surface temperatures will be hot. Use caution when touching these areas to

avoid injury.

:

Ceramic elements operate at high temperatures.

. Incorporated into the front surface of the element is a

. As the element reaches a certain temperature the decal will change from red

to black. The decal will remain black until the element falls below the transition temperature

where it will then return to its original red color. However, the element even if red will still be

extremely hot. This color changing decal is used only for determining if element is operational.

Caution

Warning

External Surface Temperatures

Severe Burns - Ceramic Elements

Do not touch elements after power is

applied to the elements

red color

changing decal

Содержание CFHS-16









Отзывы: