A P S X - P I M D E S K T O P I N J E C T I O N M A C H I N E
APSX, LLC. 2017 –
www.APSX.com
-
T
O
O
L
S
A
N
D
A
C
C
E
S
S
O
R
I
E
S
3
9
TOOLS AND ACCESSORIES
Kill-A-Watt
Kill-A-Watt meter is used to monitor the power consumption during the machine
operation to ensure all the power consuming parts are in good working condition.
The LCD screen shows all meter readings: Volts, Current, Watts, Frequency and
Power. Press the Watt/VA key once. Watts will be displayed as the active power.
Connect the Kill-A-Watt to 120V power and then to APSX-PIM power cord.
The LCD display should show the following readings for each condition below:
-
SYSTEM ON: only motors are on approximately (150W)
-
HEAT ON: only Nozzle Heater ON approximately (400W)
-
HEAT ON: Band Heater is also ON approximately (1400W) when the set
temperature is higher than current temperature.
15/16” Wrench
Use it for turning the clamp or spring ballbearings/washers manually from the
sides. Simply attach the wrench to the nut on the sides next to Block 1 or Block 7
